| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-10
Bow Thruster Room Watertight Door
Below Main Deck, Starboard Side, Watertight
Bulkhead 17
(4) Break glass on FM-200 pull station.
NOTE
Actual location may vary slightly between vessels.
Initiate actuating the FM-200 fixed fire fighting system for the tunnel by breaking the glass
for access to the pull handle.
Pull Stations are found in the following areas:
(a) Tunnel Interior Remote FM-200 Pull Station located in the Engine Room
(3-25-0-E), starboard side, watertight bulkhead 25.
(b) Tunnel Exterior Remote FM-200 Pull Station located on the Main Deck
Weather Area (1-0-0-WEA) port side, watertight bulkhead 28. This exterior
watertight pull station requires first opening the watertight cover to expose
the glass.
(5) Pull lever on FM-200 pull station. Actuate the FM-200 system by pulling the handle. The
lever requires less than 40 pounds force and 6 inches of pull to operate. Allow no one to
enter the protected space until authorized to do so.
WARNING
In the event the FM-200 system electric horn/strobe or warning
lights (amber strobe) are activated, leave the protected space
immediately. FM-200 is being released within 60 seconds, death
or serious injury could occur.
NOTE
Upon actuation of the FM-200 fire extinguishing system, a sixty
(60) second time delay before agent discharge will be experienced.
During this delay, FM-200 system electric horn/strobe will sound,
FM-200 warning bell will sound continuously and the FM-200
warning light (amber strobe) will be illuminated.
As a fail safe mode, actuation of the FM-200 Fixed Fire Extinguishing system will result in
the automatic shutdown of the following powered ventilation system motor affecting the
protected space.
Tunnel Supply Fan SF-3
If FM-200 system fails to operate, proceed to the CO Control Cylinder located in the Engine
Room (3-25-0-E), Frame 25 and follow Local Manual Release Instructions posted at the CO
cylinder location.
Change 10
2-727
|
||
|
||
