Custom Search
 
  
 
TM 55-1905-223-10
Check/replace hoses
Check/tighten mounting bolts
Check safety controls
Inspect reduction gears
Bi-annual
Clean and calibrate injectors
Check turbocharger clearances
Check vibration dampner
Clean crankcase breather
Replace water pump
NOTE: Inspect exhaust system integrity. Check for leaks. Draining and flushing of the engine cooling
system is required at 36 month intervals, this is normally included in the OCCM repair specification.
Standard:. No leaks in lube oil, fuel oil, water and exhaust systems. Engine oil pressure should be 20 psi at
idle, 45-70 psi at full speed. Water temperature should not exceed 195F at full speed. Reduction gear oil
pressure should be 250 psi when gear is warmed up. Engine responds smoothly to controls from all stations
without surging or hesitation. Engine and drive train do not vibrate excessively. Shaft brake engages within 7
seconds when engine is shifted into stop and releases immediately when engine is shifted to ahead or astern
operation. Oil analysis reports and oil consumption should indicate normal conditions and consumption. Log
should indicate accomplishment of all required P/M services listed above as applicable (annual services at
interim inspection, annual and bi-annual services at pre-OCCM inspection.
______________________________________________________________________________________
______________________________________________________________________________________
______________________________________________________________________________________
______________________________________________________________________________________
______________________________________________________________________________________
e.
Condition: Test operate, observe that unit accepts, shares, and transfers load, unit responds to speed and load
sharing controls, substantially constant frequency is maintained during load changes, overspeed trip is
operational. Inspect fuel oil, lube oil, engine cooling water and exhaust systems (check lagging) for leaks.
Pressures and temperatures are in normal range. Observe for excessive vibration. Review log for unusual or
abnormal operating conditions or incidents.  Review oil analysis reports and oil consumption records for
abnormal conditions and excessive oil consumption. Check log for accomplishment of following P/M services
as applicable:
Annual
Change 8 G-73


 


Privacy Statement - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business