| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-1
CAUTION
It is extremely important that machine bolts be tightened to the
proper torque value; otherwise, leakage could occur causing
severe damage to the engine.
(5) Remove guide studs and install the remaining two lockwashers (8) and machine bolts (7). Tighten
machine bolts (7) alternately and evenly to 30 ft-lb (40 N-m).
(6) Fill replacement fluid filter elements (6) with clean engine lube oil.
CAUTION
Mechanical tightening may distort threats or damage fluid filter
element seals.
(7) Install five fluid filter elements (6). Tighten by hand until the fluid filter element seal touches the lube
oil filter assembly (5). Tighten an additional one-half to three-quarters turn.
(8) Attach pre-lube oil line (4) to filter assembly (5).
b. Add engine lube oil.
(1) Fill the crankcase to the "H" mark on the dipstick or on the sight gauge.
(2) Start engine (TM 55-1905-223-10) and check for leaks. Correct any leaks found.
(3) Shut down engine (TM 55-1905-223-10) and allow 15 minutes for lube oil to drain back into engine oil
pan.
(4) Recheck oil level. Add lube oil, if necessary.
2-85
|
||
|
||
