| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-1
c. Support water pump housing (12) in arbor press with drive port of housing
down.
d. Using arbor press (1, FIG. 3-2), apply pressure to impeller end of straight
shaft (2) to remove shaft from water pump housing (12, FIG. 3-1)
e. Remove seal (10).
f. Remove retaining ring (1).
g. Remove rigid shaft coupling (2).
h. Remove valve seat (9).
i. Remove retaining ring (8).
CAUTION
Do not damage the end of the shaft if it is to be installed again.
j. Using a hydraulic press (1, FIG. 3-3), support the large annular ball
bearing (2) as shown.
k. Remove the small annular ball bearing (3), sleeve spacer (4) and the large
annular ball bearing (2) from the shaft (5).
l. Remove drain cock (13, FIG. 3-1).
FIGURE 3-3. Shaft Removal.
3-16
|
||
|
||
