| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-1
c. Remove camshaft (9).
NOTE
The camshafts are different for the right and left bank.
Tag the parts for future assembly.
(1) Use a dial indictor to measure camshaft end clearance (FIG. 3-18).
(2) Use a hammer and a drift to bend the lockplates (12, FIG. 3-17) from the heads of the hexagon
head capscrews (13).
(3) Remove hexagon head capscrews (13) and lockplates (12) from shaft retaining plate (11).
CAUTION
Two soldiers are required when removing the camshaft
to prevent damage to the camshafts and bushings.
Turn
the
camshaft
gently
clockwise
and
counterclockwise while pulling camshaft out.
(4) Rotate and slightly lift camshaft gear (14) while removing camshaft (9) from block.
CAUTION
Do not touch the machined surface with bare hands
after the camshaft has been cleaned. This will cause
rust to form.
FIGURE 3-18. Camshaft End Clearance Measurement.
3-75
|
||
|
||
