| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-1
i. Remove bearing (45) and spring washer (44) from housing (35).
j. Remove screws (53) and hammer assemblies (52) from the carrier shaft (34).
k. Remove retaining rings (51) and planet shafts (46). Remove washers (47 and
1. Remove ring gear (29).
m. Remove screws (31) and retainer plate (30).
n. Remove press bearing (26) and woodruff key (27) from sungear/shaft (28).
Remove sungear/shaft (28).
o. Remove screws (1) retaining plate assembly (2) to turbine housing (25).
Remove plate assembly (2).
p. Remove screw (3) and washer (4). Remove turbine wheel (5).
q. Remove screws (7) retaining lip seal (6). Remove seal (6) from the seal
housing (8). Remove seal housing (8).
r. Remove performed packing (9), spacer (10), bearing (11), performed packing
(12), spring seat (13), spring (14), and spacer (15) from nozzle/liner (16).
s. Remove nozzle/liner (16), nozzle gasket (32), and performed packing (33).
t. Remove screws (20 and 22), retaining ATV (21). Remove the ATV (21).
u. Remove ATV gasket (19) and straight headless (dowel) pins (17).
v. Remove set screw (23), vent plug (24), and pressure plug (18) from turbine
housing (25).
REPAIR
Repair of the engine air starter is by replacement of defective parts.
ASSEMBLY
a. Install vent plug (24), set screw (23), and pressure plug (18) in turbine
housing (25).
b. Install ATV gasket (19) and straight headless (dowel) pins (17) on turbine
housing (25).
c. Position ATV (21) on turbine housing (25). Secure ATV with screws (20 and
22).
d. Install performed packing (33), nozzle gasket (32), and nozzle liner (16) on
turbine housing (25).
3-102
|
||
|
||
