| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-1
e. Install spacer (15), spring (14), spring seat (13), performed packing (12),
bearing (11), bearing (10), and performed packing (9) in nozzle/liner (16)
.
f. Install seal (6) in seal housing (8). Install housing (8) in nozzle/liner
(16). Secure with screws (7).
g. Install turbine wheel (5) in nozzle/liner (16). Secure with washer (4) and
screw (3).
h. Install plate assembly (2) on turbine housing (25). Secure with screws (1).
i. Install bearing (26) and woodruff key (27) on sungear/shaft (28). Install
sungear shaft (28).
j. Install retaining plate (30). Secure with screws (31).
k. Install ring gear (29) on turbine housing (25).
l. Install planet shafts (46) and retaining rings (51). Install washers (50),
m. Install hammer assemblies (52). Secure with screws (53).
n. Install spring washer (44) and bearing (45) in gearbox housing (35).
o. Slide gearbox housing (35) on sungear/shaft (28).
p. Secure gearbox housing (35) with screws (43).
q. Install bushing (36), bearing (37), and retainer plate (38) to gearbox
housing (35). Secure with screws (39).
r. Install lockwasher (41) and retainer nut (40).
s. Install spring assembly (54) and set screw (55) in Bendix gear (56).
t. Slide Bendix gear (56) on carrier shaft (34).
u. Install lip seals (60) and bearing (59) in drive assembly housing (58).
v. Install drive assembly housing (58) on gearbox housing (35). Secure with
screws (57) and nuts (42).
w. Install engine air starter (paragraph 2-14).
3-103
|
||
|
||
