| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-1
ASSEMBLY
NOTE
If new parts are used, be sure all of the oil
preservative has been removed.
a. Use a suitable arbor press and a roller pin block to assemble the rollers 2 (5, FIG. 4-39) and pin (2) as
follows:
(1) Position the roller (5), pin (2), and cam follower (7) in the press.
(2) Align the oil passage and roll pin holes in the cam follower (7) and roller (5).
(3) Select the proper thickness feeler gauges (1, FIG. 4-42). Place the gauge (1) between the roller (5)
and cam follower (4) for support while pressing the pin (2) into the lever.
NOTE
The roller (5) to cam follower (4) side clearance
must be 0.009 to 0.024 inch (0.23 to 0.61 mm)
after the pin (2) is pressed into place.
(4) Press the roller pin (2) into the cam follower (4) and roller (5)until it is flush.
FIGURE 4-42. Cam Roller Pin Installation.
4-35
|
||
|
||
