| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-10
Table 2-1.
Preventive Maintenance Checks and Services - CONT
D - Daily
M - Monthly
Q - Quarterly
S - Semiannually
A - Annually
B - Biennially
Item
Interval
Items To Be
Procedures
No.
Inspected/Servic
D M QS A B
15
Oil level - CONT
(6)
Add oil until visible in sight glass.
CONT
(7)
Install oil fill plug in top of gear case
housing.
16
Winch Assembly
Give the winch assembly a thorough visual inspection.
Look for anything that is leaking, loose, broken,
torn, missing, or out of the ordinary. Secure,
repair, or replace defective components.
17
Outboard Drum Bearing
Refer to LO 55-1905-223-12, Lubrication Order.
Lubricate the outboard bearing in the winch assembly.
18
Slack Wire Limit Switch
Refer to LO 55-1905-223-12, Lubrication Order.
Lubricate the slack wire limit switch. This
switch is mounted near the brake release pump of
the winch assembly. If control system shows
slack/overlapped cable indication, adjust
slack/overlapped cable detector bail as follows:
(1)
Turn off electric motor in hydraulic power
pack assembly. Tag the three control
panels "Out of Service - Do Not Operate."
(2)
Loosen screw and nut securing detector bail
to switch actuating arm until bail rotates freely in arm.
(3)
Position bail 3/16 inch from the lowest
surface of the cable on the drum and tighten arm
screw and nut.
2-15
|
||
|
||
