| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-15
NOTE
Observe direction of beveled edge of encased seal to ensure correct positioning during
replacement.
h. Remove the encased seal (1). Discard the seal.
i. Remove the ball bearing (3).
j. Remove the torque pins (8).
k. Remove the shaft (9).
l. Remove the spring (7) and spring retainer (6).
m. Remove the gasket (5). Discard the gasket.
REPAIR
NOTE
This item is a candidate for direct replacement.
a. Inspect the discs (10 and 12) for cracks, warping, or other physical damage. Replace as required.
b. Inspect the friction lining (11) for discoloration due to excess heat, or other physical damage. Replace as
required.
c. Inspect the piston (13) for scoring, warping, or other physical damage. Replace as required.
WARNING
High pressure compressed air tanks, piping systems, and air operated devices possess potential
for serious injury to the eyes and exposed areas of the skin due to escaping air pressure.
d. Clean all parts thoroughly with low pressure compressed air.
e. Check the bearings (3) for proper lubrication, lubricate if needed (Item 9, Appendix C).
4-27
|
||
|
||
