| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-16
FIGURE 4-40. Retaining Ring.
c.
Check outside diameter of shaft at point of contact with bearing or seal. If unusual wear, damage brought on by
warpage or metal stress, chips or cracks are revealed, pump shaft must be replaced.
CAUTION
Retaining ring must be removed by passing over the bearing surface area of the shaft and not the shaft
seal surface. Damage to the seal surface will cause the seal to leak.
d. If bearing is defective, remove retaining ring (7) and press bearing (6) from the shaft (3). Remove retaining ring
(5) by passing over bearing sur-face area of shaft.
4-86
|
||
|
||
