| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-18-1
Remove the hexagon cap screws and self-locking nuts (2) that secure the gauge
j.
to the panel.
k.
Gently pull the gauge away from the panel.
REPAIR
Repair of the diesel fuel oil filter/separator at the unit level is the
replacement of the differential pressure gauge, fluid filter elements and stud
seals.
ASSEMBLY
a.
Install the differential pressure gauge (4, FIGURE 2-13) by replacing the
hexagon cap screws and self-locking nuts (2).
Install the tubes to the differential pressure gauge (4) by tightening the
b.
tube coupling nuts (1).
Install fluid filter elements (6 and 9, FIGURE 2-12).
c.
Install stud seals (5), flatwashers (4) and hexagon self-locking nuts (3).
d.
Close the machining end cap (1) and secure with swing bolts (2).
e.
hexagon nuts to 35 ft-lbs.
f.
Close drain valve (7).
Make sure vent valve (10) is open. Open inlet valve (8) and when all air has
g.
escaped from filter housing, shut vent valve (10).
Test system.
h.
2-226
|
||
|
||
