| Tweet |
Custom Search
|
|
|
|||||
|
|||||
 TM 55-1905-223-24-18-1
Place assembled transmission, balance ring, and pivot dome groups on outer
o.
tub assembly.
Install leg plates (11 and 12, FIGURE 2-69), align legs, and secure with
p.
assembled washer screw (10).
Install grommet (13) and pressure accumulator (14).
q.
r.
Install pressure hose (16) using hose clamp (15).
NOTE
Tape pressure hose (16) to outer tube near
top of unit for easy access when installing
later in procedure.
When reinstalling the complete tub assembly,
the idler lever is in the way and can be
damaged (bent), or the idler pulley could be
chipped. Ensure the idler spring is
disconnected and move the idler lever out of
the way. T h i s will prevent the possibility
of idler lever or pulley damage.
s.
Lift complete tub (with transmission, balance ring, and pivot dome attached)
and turn right side up.
Lower outer tub into washer cabinet.
t.
Install centering spring (9) to notch on outer tub marked during removal.
u.
Install performed hose (16, FIGURE 2-73) with hose clamp (17, 9).
v.
Install spring (27, FIGURE 2-74) in idle lever (9).
w.
Apply a thin bead of sealant around on inside of outer tub flange.
x.
Install encased plain seal (9, FIGURE 2-70) and secure with lockwasher (8)
y.
and hexagon plain nut (7). Torque nut to 40 - 70 ft. lbs. (54.23 - 94.91
Nm).
Place gasket (6) on washtub (5) after applying petroleum jelly (ensure hole
z.
alignment between tub and gasket).
aa.
Install lint filter (2) on washtub using fastener (1).
ab.
Install washtub and secure using gasket (4) and hexagon head capscrew (3).
ac.
Install cover gasket (6, FIGURE 2-69) (lubricate with liquid soap before
installation).
2-376
|
|||||
|
|||||
