| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-18-1
Remove locknut (2) and motor shield (1).
o.
Remove push switch (33).
p.
REPLACEMENT
a.
Install push switch (33).
b.
Install motor shield (1) and locknut (2).
c.
Install motor pulley (4) and spring pin (5).
d.
Install motor pulley (32) and headless straight pin (6).
e.
Install resilient motor mount (30) and flat washer (31).
f.
Install motor (3).
Install spacer (24), resilient mount (23), flat washer (22), and locknut
g.
(21).
h.
Install ground clip (20) and wire clip (26).
i.
Install motor bracket (28) and machine screw (29).
NOTE
Do not tighten machine screw (29) until V-
b e l t (18) is installed.
I n s t a l l V-belt (18).
j.
k. Install hexagon head capscrew (25).
l.
Install idler lever (9), flat washer (10), shoulder bolt (11), and lock nut
(7).
m.
Install idler shaft (12) and locknut (8).
n.
Install felt washer (13), idler pulley (17), felt washer (14), flat washer
(15), and retaining ring (16).
o.
I n s t a l l V-belt (19).
I n s t a l l spring (27).
p.
Refer to paragraphs 2-83 and 2-86.
q.
ADJUSTMENT
To adjust V-belt (18) perform the following:
a.
2-383
|
||
|
||
