| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-18-1
NOTE
Adjustment must be made after motor (3) has
been properly positioned to limit of travel
to rear of washer within mounting bracket
(28) attaching screws (29).
(1) Loosen two front pump mounting screws (14, FIGURE 2-73), then loosen rear
mounting screw.
(2) Shift front of pump mounting bracket (13) to right or left to obtain
proper belt tension.
NOTE
Proper tension is when belt can be deflected
approximately 1/2 inch (17.7 mm) from normal
position with moderate pressure (1 1/2
pounds (.675 Kg) at a point midway between
pulleys).
(3) Tighten three mounting screws (14).
2-384
|
||
|
||
