| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-18-1
Remove jam nut (14) and washer (15) from faucet (16).
l.
Repair at this level of maintenance is by replacement of the lavatory faucet (3).
NOTE
Apply teflon tape to all threaded connections prior to
assembly.
a.
Connect flared coupling (13) to faucet (16).
NOTE
Do not tighten until all nuts and fittings are installed.
b.
Install jam nut (14) and washer (15) on faucet (16).
c.
Position faucet (16) in top of lavatory.
d.
Position manifold (11) with nuts (10) and washers (9) attached in bottom of
lavatory.
e. Connect joint adapters (12) to manifold (11).
f.
Install rubber washers (8) on top of lavatory faucet (3).
Install nuts (7) on top of faucet (3).
g.
h . Tighten all nuts and fittings.
i.
Install covers (6) on top of lavatory faucet (3).
Install handles (5) on faucet (3).
j.
k.
Install screws (4) and tighten.
l.
Open cold water supply valve (1) and hot water supply valve (2).
m.
Check faucet fittings for leaks and retighten as necessary.
2-969
|
||
|
||
