| Tweet |
Custom Search
|
|
|
|||||
|
|||||
 TM 55-1905-223-24-18-2
(12) Remove four plain hex nuts (27), lockwashers (26), and machine screws (23) securing card
rack (28) to rack mount.
(13) Remove card rack.
k. Simulator float. (Figure 3-45, Sheet 3).
(1) Remove identification plate (48) from simulator float (40).
(2) Remove wing nut (44) and release connecting strip (43).
(3) Unwind electrical cable (45) from simulator float.
(4) Disconnect snub bushing (59) from simulator float. Remove electrical cable.
(5)
Remove two plain hex nuts (27), lockwashers (26), and machine screws (23) securing
simulator float (40) to support mount.
(6) Remove simulator float, wire wound variable resistor (41), and knob (42).
(7) Remove terminal marker strip (47) from terminal block (46).
(8) Tag and disconnect electrical leads from wire hook-up (52).
(9) Disconnect cable ties (53) from cable harness.
(10) Remove terminal lug (8) securing tie mounting device (54) to support mount.
(11) Remove tie mounting device.
(12) Remove two plain hex nuts (51), lockwashers (50), and machine screws (49) securing
terminal block (46) to support mount.
(13) Repeat steps (7) through (12) to remove terminal block (55) and terminal marker strips (56).
(14) Remove identification markers (56).
(15) Remove type-J jumpers (58).
l. Power supply. (Figure 3-45, Sheets 4 and 5).
(1) Unscrew and remove fuse cartridge (15) and fuse fuseholder (16) on cover plate.
(2) Remove four plain hex nuts (27), lockwashers (26), and machine screws (23) securing cover
plate to support mounts.
(3) Position cover plate to expose fuseholder (16).
(4) Tag electrical wires and clip off wire ends at fuseholder.
3-187
|
|||||
|
|||||
