| Tweet |
Custom Search
|
|
|
|||||
|
|||||
 TM 55-1905-223-24-18-2
(14) Wind electrical cable (45) clockwise onto simulator float.
(15) Position connecting strip (43) on simulator float.
(16) Install wing nut (44) and secure connecting strip to simulator float.
(17) Attach identification plate (48) to simulator float.
d. Card rack. (Figure 3-45, Sheet 2).
(1) Position card rack (28) over support mount.
(2) Install four machine screws (23), lockwashers (26), and plain hex nuts(27) and secure card rack to
support mount.
(3) Position printed circuit connector (39) over support mount on card rack (28).
(4) Install two machine screws (36) and lockwashers (37) and secure printed circuit connector (39) to
support mount on card rack.
(5) Connect electrical leads to printed circuit connector. Remove tags.
(6) Repeat steps (3) through (5) to install remaining printed circuit connectors (39).
(7) Position card guide (38) on each side of card rack (28).
(8) Install two machine screws (36) and lockwashers (37) on each side of card rack and secure card
guides to card rack.
(9) Repeat steps (7) and (8) to install remaining card guides (38).
(10) Install circuit card assemblies (35) into card rack (28).
(11) Install flasher module (34) and power supply (33) circuit cards into card rack.
(12) Attach identification markers (32) on retaining bar (31).
(13) Position retaining bar (31) over card rack (28) with mounting screw holes aligned.
(14) Install two hex head capscrews (29) and lockwashers (30) and secure retaining bar to card rack.
e. Indicator light. (Figure 3-45, Sheet 1).
(1) Position indicator light (17) and incandescent lamp (18) on front panel.
(2) Install terminal lug (8) at rear of indicator light.
(3) Connect electrical leads at rear of indicator light (17). Remove tag.
3-191
|
|||||
|
|||||
