CHAPTER 4 INTERMEDIATE GENERAL SUPPORT MAINTENANCE INSTRUCTIONS

Custom Search

Section VI. PREPARATION FOR STORAGE OR SHIPMENT

TM-55-1905-223-24-2 Main Reduction Gear for Landing Craft Utility (LCU) NSN 1905-01-154-1191 Manual

Section III. INTERMEDIATE GENERAL SUPPORT PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS)

TM 55-1905-223-24-2

CHAPTER 4

INTERMEDIATE GENERAL SUPPORT MAINTENANCE INSTRUCTIONS

Page

Section I

Repair Parts, Special Tools; Test, Measurement, and Diagnostic Equipment (TM E); and Support

Equipment ................................ ................................ ................................ ................................ .... 4-1

Section II

Service Upon Receipt ................................ ................................ ................................ ...................

4-1

Section III

Intermediate General Support Preventive Maintenance Checks and Services (PMCS).................

4-2

Section IV

Intermediate General Support Troubleshooting................................ ................................ .............

4-2

Section V

Intermediate General Support Maintenance Procedures................................ ...............................

4-3

Section VI

Preparation for Storage or Shipment................................ ................................ .............................

4-32

Section I. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT,

AND DIAGNOSTIC EQUIPMENT (TMDE); AND SUPPORT EQUIPMENT

4-1. Common Tools and Equipment. For authorized common tools and equipment refer to the Modified Table of

Organization and Equipment (MTOE) applicable to your organization.

4-2. Special Tools, TMDE, and Support Equipment. Special tools; test, measurement and diagnostic equipment;

and support equipment requirements are listed and illustrated in the Repair Parts and Special Tools List (RPSTL),

TM 55-1905-223-24P. These items are also listed in the Maintenance Allocation Chart (MAC), Appendix B of this

manual.

4-3. Repair Parts. Repair parts are listed and illustrated in the Repair Parts and Special Tools List (RPSTL), TM 55-

1905-223-24P.

Section II. SERVICE UPON RECEIPT

4-4. Checking Unpacked Equipment.

a. Inspect the equipment for damage incurred during shipment. If the equipment has been damaged, report the

damage in accordance with the instructions in DA Pam 738-750.

b. Check the equipment against the packing slip to see if the shipment is complete. Report all discrepancies in

accordance with the instructions in DA Pam 738-750.