FIGURE 2-25. Installing the Arms and Levers on Shaft.

Custom Search

FIGURE 2-24. Set Screw and Oil Passage Holes.

TM-55-1905-223-24-3 Ship s Service Generator for Landing Craft Utility (LCU) NSN 1905-01-154-1191 Manual

FIGURE 2-26. Rocker Housing Gaskets and Guide Studs.

TM 55-1905-223-24-3

FIGURE 2-25. Installing the Arms and Levers on Shaft.

REPLACEMENT

NOTE

Be sure that the covers, housing, and cylinder head surfaces are clean before installing gaskets (9 and 20).

a. Install new rocker lever housing gaskets (2, Figure 2-26) on the cylinder heads.

b. Install two rocker lever guide studs (1) in each cylinder head.

NOTE

Return each housing to its original position on the engine.

Install each rocker lever housing (18, Figure 2-23).

CAUTION

If the adjusting screws protrude beyond the maximum of 1.259 inches from the

top surface of the lever and the ball end of the adjusting screws, the push rods

can be damaged when the housing capscrews are tightened.

2-113