| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-3
FIGURE 2-24. Set Screw and Oil Passage Holes.
c.
Install, in their original location, the exhaust rocker arm (1), injector rocker lever (2), and intake rocker
arm (3) as the shaft is pushed through the rocker lever housing (18, Figure 2-23).
d. Install, in their original position, the intake rocker arm (1, Figure 2-25), injector rocker lever (2), and
exhaust rocker arm (3) as the shaft continues through the rocker lever housing (18, Figure 2-23).
e. Install the preformed packing (22) as follows:
(1)
Push the straight shaft (23) until 0.50 inch (12.7 mm) extends from the rocker lever housing (18).
(2)
Lubricate the packing (22) with vegetable oil.
(3)
Install the lubricated packing.
(4)
Push the straight shaft (23) until the other end extends 0.50 inch (12.7 mm) from the rocker lever
housing (18).
(5)
Install the lubricated packing.
f.
Align the straight shaft (23) and the rocker lever housing setscrew holes. See (4) and (5) Figure 2-24.
g. Install the setscrew (24, Figure 2-23).
2-112
|
||
|
||
