| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-3
d.
Apply a coat of clean lubricating oil to a new preformed packing (2, Figure 3-11). Place packing between the
element (3) and the housing (12). -Ensure that the packing does not protrude over the element and housing.
NOTE
The packing must be installed in less than 1 hour after the oil is applied.
e.
Push the packing (2) into the housing. Using "O" ring mandrel. Tap mandrel with a plastic hammer until it is
against the element and housing.
f.
Install the retaining ring (1). Ensure that the part number on the ring face out.
s
g.
Install a new gasket (13) and the cover (14) to the housing (12). Tighten the assembled washer screws (15) to 30
to 35 ft-lb (40.6 to 47.4 N ) torque.
m
h.
Slide the housing to the edge of the workbench until you can hold the element in position with your hand. Ensure
that the element does not move in the housing. Place the housing with the cover end down onto the workbench.
i.
Repeat steps (d), (e), and (f) to install the packing (4, Figure 3-1l) and retaining ring (1).
j.
Install a new gasket (8) and the support (5) to the housing (12). Tighten the hexagon capscrews (7) and
lockwashers (6) to 30 to 35 ft-lb (40.6 to 47.4 N m) torque.
k.
Install any pipe plugs that were removed.
l.
Tighten the 1/4 inch pipe plug to 25 ft-lb (33.8 N m) torque.
Tighten the 1/8 inch pipe plug to 7 ft-lb (9.4 N ) torque.
m.
m
n.
Install the plunger (2, Figure 3-12), compression spring (3), spacer (4), and machine thread plug (5) into the
support housing (1) and tighten the plu to 20 ft-lb (25 N ) torque.
g
m
o.
Mount the cooler/filter group on the engine (paragraph 2-24) and install a new filter.
3-41
|
||
|
||
