| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-3
(3)
Place a flat steel plate on top of the wear sleeve (10).
(4)
Press the wear sleeve (10) on the pulley (14) u til the steel plate contacts the pulley.
n
(5)
Inspect the wear sleeve (10) for obvious damage during assembly.
REPLACEMENT
CAUTION
If the crankshaft was rotated after the accessory drive was removed, rotate the
crankshaft until the timing mark on the camshaft gear is visible in the inspection
hole before installing the accessory drive assembly. See Figure 3-33.
NOTE
Ensure mounting surfaces are clean of dirt and debris before installing the accessory drive.
a. Install a new gasket (15, Figure 3-31) on the accessory drive assembly.
CAUTION
Ensure the dowel pin has been inserted correctly before installing the accessory
drive. See Figure 3-34.
b. Put the accessory drive shaft dowel pin at approximately the 11:30 o'clock position when facing the
shaft from the pulley end.
c.
Install the accessory drive assembly in the gear housing accessory drive mounting hole.
d. Check the alignment of the camshaft gear and the accessory drive gear timing marks through the
inspection hole in the gear cover (Figure 3-33).
NOTE
The accessory drive shaft dowel pin will be at the 12:00 o'clock position after the
accessory drive is installed.
e. Install and tighten the accessory drive washer screws (5, Figure 3-31) to 45 ft-lb (61.0 N ) torque.
m
f.
Apply anti-seize thread compound to the 3/8-inch inspection hole pipe plug (Figure 3-32).
g. Install and tighten the plug to 20 ft-lb (30 N ) torque.
m
h. Install a new accessory drive seal in the gear cover (paragraph 3-20):
3-73
|
||
|
||
