| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-3
CAUTION
Do not use any kind of lubricant to install the seal. The oil seal must be installed
with the lip of the seal and the seal wear area of the accessory drive pulley clean
and dry. Use of lubricant will result in oil leakage at the seal.
(1)
Install the oil seal with the closed or part number side facing outward from the gear cover.
(2)
Install the oil seal over the accessory drive pulley shaft.
(3)
Push the seal into the gear cover seal bore until the seal is seated.
i.
Install the accessory drive flat pulley assembly:
(1)
Apply a film of Lubriplate or its equivalent to the accessory drive shaft.
(2)
Align the keyway in the pulley with the dowel pin in the shaft.
(3)
Use your hand to partially push the pulley on the shaft.
(4)
Using pulley installation tool, press the pulley onto the shaft until it fits against the accessory drive
gear.
(5)
Install the keyway rubber strip (13, Figure 3-31) in the pulley keyway with one end of the seal
pointing toward the center line of the shaft.
(6)
Install the washer (11, Figure 3-31) and the nut (12) on the accessory drive shaft. Tighten the nut
to 30 ft-lb (40.6 N ) torque.
M
j.
Install the fuel pump (paragraph 2-37).
k.
Install the water pump belt (paragraph 2-33).
l.
Connect battery banks (starboard), operate air system (port), refer to TM 55-1905-223-10.
m. Run the engine and check for leaks.
3-74
|
||
|
||
