| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-3
f.
Disconnect the sump pump from the shutoff valve (12). Remove the machine thread plug (10), the
pipe nipple (11) and shutoff valve (12).
g. Remove the 32 capscrews (19, 20) that hold the oil pan in place.
h. Remove the oil pan (4) gasket (1). Discard gasket.
i.
Remove the two thread forming tapping screws (2) and remove sediment strainer element (3).
REPAIR
a. Clean the nonmetallic hose assembly (8, Figure 3-44) and the mounting flanges. Clean the sediment
strainer element (3). Inspect the nonmetallic hose assembly (8) and element (3) for damage. Replace
as required.
b. Clean the mounting capscrews.
c.
Visually inspect the hose and the flanges for cracks, corrosion, or other damage. Replace if damaged.
d. Visually inspect access cover (14), dipstick tube (17), and rod-cap (16) for damage.
Replace if
damaged.
e. Visually inspect the pan (4) for signs of cracks or other damage. Replace the oil pan (4) if damaged.
REPLACEMENT
a. Install the sediment strainer element (3) in the oil pan (4) with thread forming tapping screws (2).
NOTE
Ensure the gasket surfaces are clean before installing oil pan.
b. Install two guide studs into the oil pan flange of the cylinder block.
NOTE
Use a contact adhesive to attach the new gasket to the oil pan. The silicon
printed side of the gasket must be towards the oil pan.
3-87
|
||
|
||
