| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-3
c.
Install new gasket (1) and position oil pan (4) on the engine block. Install the capscrews (19, 20, Figure
d. To prevent damage to the oil pan or flywheel housing, use following sequence to tighten capscrews.
(1)
Install and tighten the middle capscrew in each buttress on the flywheel housing (Figure 3-45).
(2)
Tighten two capscrews on each side of the oil pan flange. Tighten the capscrews that are located
halfway between the front and the rear of the oil pan (Figure 3-46).
(3)
Remove the capscrews that were installed in step d.(1) of this procedure. This is necessay to
r
provide the clearance to perform the following step.
(4)
Install and tighten capscrews to hold the rear corners of the oil pan to the cylinder block.
(5)
Remove the guide studs and install all oil pan capscrews.
(6)
Tighten the capscrews that hold the oil pan to the cylinder block and front cover to 35 to 40 ft-lb (47
to 54 N ) torque.
M
FIGURE 3-45. Flywheel Housing Buttresses.
3-88
|
||
|
||
