| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-3
b.
Loosen the connecting rod machine bolts (5, Figure 3-57).
NOTE
Do not remove the machine bolts from the rods.
c.
Use a rubber hammer to hit the connecting rod bolts (5, Figure 3-57) to loosen the cap (6) from the
piston pin (4) in the connecting rod (1).
d.
Ensure connecting rod and the cap have matching numbers stamped on them and that they are in the
correct cylinder location.
e.
Remove the connecting rod bolts (5).
f. Remove the lower rod cap (6) and lower rod bearings (3). Mark the cylinder number and the letter "L"
in the flat surface of the bearing tang.
g. Remove the upper rod bearings (2). Mark the cylinder number and the letter "U" in the flat surface of
the bearing tang.
FIGURE 3-57. Connecting Rod and Piston Group.
3-105
|
||
|
||
