| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-3
CAUTION
Be careful when you expand the sleeve. Do not damage the sleeve and O-ring.
1
Install the expander into the sleeve. Use an inch-pound torque wrench to turn the mandrel of
the expander.
2
Turn the mandrel until the torque wrench indicates 75 in-lb (8.4 N m).
(i)
Remove the expander and the holding tool from the sleeve.
(j)
Use the injector seat cutter to cut the injector seat in the sleeve.
1
Install the injector in the cylinder head; tighten the capscrews to 10 to 12 ft-lb (13 to 16 N m)
torque.
2
Use the gauge block to measure the protrusion of the injector tip to find the amount to cut from
the sleeve (Figure 4-16).
3
The protrusion of the injector tip must be 0.060 to 0.070 inch (1.52 to 1.78 mm). Remove the
injector.
FIGURE 4-16. Using Gauge Block.
4-46
|
||
|
||
