| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-5
FIGURE 3-24. Torque Methods .
WARNING
The injector plunger is under spring tension. Do not allow the tool to slip. Personal
injury can result.
(n) Actuate the injector rocker level several times. Allow the lever to return slowly to prevent
damage to the dial indicator. Hold the injector plunger to the bottom of its travel, and confirm
the "O" (zero) reading on the dial indicator.
(o) Allow the injector rocker level to return slowly. Check the reading on the dial indicator.
Repeat the adjustment process if the reading is not within specifications.
(p) Adjust the crossheads and the valves on cylinder No. 5 before rotating the accessory drive to
the next valve set mark. Refer to Cross head Adjustment and Valve Adjustment in this
procedure.
(q) After adjusting the crossheads and the valves on cylinder No. 5, rotate the accessory drive;
align the next valve set mark on the accessory drive pulley with the pointer on the gear
cover.
(r) Adjust the appropriate injector, the cross heads, and the valves. Follow Table 2-4, Valve and
Injector Adjustment Sequence Chart.
(s) Repeat the process to adjust all the injectors, the cross heads, and the valves correctly.
(4) Injector Preload Adjustment Procedures (Top-stop Injectors Only).
3-38
|
||
|
||
