| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-5
REPAIR
Repair consists of replacement of gaskets (2, 4, 6) and housing (20).
REPLACEMENT
CAUTION
Ensure gasket sealing surfaces are clean.
a.
Clean cam follower parts with cleaning solvent, and dry with compressed air.
b.
Install the new cam follower gaskets-(2, 4, 6) to the block as follows:
(1)
One gasket is required for each cam follower housing.
(2)
The gasket must be installed against the block with the sealing bead toward the cam
follower housing.
(3)
Measure the gasket (2, 4, 6) thickness. The replacement gaskets must be the same
thickness as the gaskets which were removed.
(4)
Install the gaskets (2, 4, 6) on the block.
c.
Install the cam follower (20) in the block as follows:
(1)
Install six capscrews (17) in each cam follower housing.
(2)
Tighten the capscrews in the alternating sequence shown to the following torque values
Figure 3-34.
Cam Follower Housing Torque Sequence .
3-51
|
||
|
||
