| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-5
CAUTION
If the crankshaft was rotated after the accessory drive was removed, rotate the
crankshaft until the timing mark on the camshaft gear is visible in the inspection hold
before installing the accessory drive assembly. See FIGURE 3-41.
NOTE
Make sure mounting surfaces are clean of dirt and debris before installing the accessory
drive.
c.
Install a gasket (15, FIGURE 3-40) on the accessory drive housing (17).
CAUTION
Make sure the dowel pin has been inserted correctly before installing the accessory
drive. See FIGURE 3-44.
d.
Put the accessory drive shaft dowel pin (13, FIGURE 3-40) at approximately the 11:30
o'clock position when facing the shaft from the pulley end.
e.
Install the accessory drive assembly in the gear housing accessory drive mounting hole.
f.
Check the alignment of the camshaft gear and the accessory drive gear timing marks
through the inspection hole in the gear cover (FIGURE 3-43).
NOTE
The accessory drive shaft dowel pin will be at the 12 o'clock position after the accessory
drive is installed.
g.
Install and tighten the five accessory drive mounting capscrews (5, FIGURE 3-40) to 45 ft-lb
h.
Apply pipe sealant to the 3/8 inch inspection hole pipe plug.
i.
Install and tighten the plug (FIGURE 3-42) to 20 ft-lb torque.
j.
Install a new accessory drive seal in the gear cover. Refer to paragraph 3-20.
3-67
|
||
|
||
