| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-5
(3)
Tighten the three capscrews alternately in 1/2-turn increments until top plate seals
against the crankshaft nose.
(4)
Remove the top plate and capscrews.
l.
Install the PTO housing (2, FIGURE 3-43) onto the gear cover.
m.
Relieve tension on the hoist to set the housing (2) on the engine supports (1). Install the
support capscrews (4) and lockwashers (3). Tighten the capscrews to 50 ft-lb torque.
n.
Install the crankshaft pulley (paragraph 3-19).
o.
Install the accessory drive seal (paragraph 3-19).
p.
Install the dowel pin in the accessory drive shaft (if removed) (FIGURE 3-49).
q.
Install the accessory drive pulley (paragraph 3-19).
r.
Install the water pump belt (paragraph 2-29).
s.
Install the four capscrews that hold the oil pan to the gear cover.
t.
Tighten one of the 7/16 inch oil pan mounting capscrews on each side of the oil pan, halfway
between the front and the rear of the oil pan, 15 ft-lb torque.
u.
Tighten the four 5/16 inch capscrews in the rear of the oil pan to 20 ft-lb torque in the
sequence shown (FIGURE 3-53).
v.
w.
Install the seawater pump belt and belt/guard (paragraph 2-37).
x.
Install the Power Takeoff (paragraph 3-20).
y.
Fill the lubricating oil system (PMCS Table 2-1, Item 12).
z.
Run the engine (TM 55-1905-223-10) until it reaches a temperature of 180 (80 ) and
F
C
check for leaks.
3-76
|
||
|
||
