| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-5
(r) Tighten the thirty (32) 7/16-inch capscrews to 50 ft-lb (70 N ) torque in the sequence shown.
m
(9) Install the flywheel.
c. Install the flywheel.
(1) Install the pilot bearing in the flywheel:
(a) Use a 240 grit emery cloth to clean the pilot bore.
(b) Use a mandrel and a hammer to install the pilot bearing.
NOTE
The pilot bearing must be installed flush with the pilot bore surface (FIGURE 3-98) .
FIGURE 3-98. Install Pilot Bearing.
(c) Install two 5/8-18 x 6 inch guide studs in the crankshaft flange.
(d) Install two T-handles in the flywheel for lifting.
WARNING
Because the flywheel weighs more than 50 lb (23 kg), two people or a hoist will
be required to lift the part to avoid personal injury.
(e) Install the flywheel on the guide stud.
(f)
Lubricate the threads of the capscrews and the surface of the washers with 15W-40 engine
lubricating oil.
(g) Install the four capscrews and washers.
3-136
|
||
|
||
