| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-5
w.
Adjust the clutch assembly by the following procedure:
(1)
With the clutch disengaged, turn the clutch until the adjusting lock pin (41) can be reached
through a hand hole (40). Depress the pin (41) with a screwdriver and screw the adjusting ring
clockwise one or two notches or until a distinct pressure is felt with the hand lever (57).
(2)
Release the adjusting pin (41) and turn the adjusting ring (40) to engage the nearest notch with
the pin (41).
(3)
Engage and disengage the clutch a number of times to check the operation. If proper adjustment
has not been accomplished, repeat steps (a) and (b) until proper engagement and
disengagement are obtained.
x.
Place instruction cover plate (53) in position on the clutch housing (32). Secure the plate (53) with two
round-head 1/4-20 x 1/2 machine screws (52). Tighten the screws (52) to 11 ft-lb. torque.
y.
Place bottom cover plate (50) in position on the clutch housing (32). Secure the plate (50) to the
housing (32) with two round-head 1/4-20 x 1/2 machine screws. Tighten the screws to 11 ft-lb. torque.
z.
If the driving ring (1) was removed, position the driving ring (1) against the engine flywheel and secure
it with eight hexhead capscrews. Torque the capscrews (Table 3-5).
aa. Install the PTO (paragraph 3-38).
4-58
|
||
|
||
