| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-5
NOTE
Align the gear keyway with the key in the camshaft, and install
the gear.
(6)
Keep the camshaft in a vertical position with the gear up until the gear
has cooled.
(7)
If the gear does not seat against the locating shoulder on the camshaft,
use a brass drift and a hammer to drive the gear up against the shoulder
(8)
Use a feeler gauge to check the clearance between the camshaft gear and
the shoulder. The clearance must not exceed 0.0050 inch (0.13 mm)
(9)
Apply a coat of Lubriplate to both sides of the thrust bearing.
(10)
Install the thrust bearing onto the camshaft.
NOTE
Make sure that the oil grooves on the thrust bearing are toward
the camshaft gear.
b. Install the camshaft (paragraph 3-22).
NOTE
The engine timing should be checked after engine assembly
(paragraph 3-32).
FIGURE 4-30. Seating the Gear and Checking Clearance.
4-64
|
||
|
||
