| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-5
(8)
Cut the inside diameter of the bore for rods with bolts and nuts to measure 3.2722 to 3.2732
inches (83.114 to 83.139 mm), or cut the inside diameter of the bore for rods with capscrews to
measure 3.3157 to 3.3167 inches (84.219 to 83.139 mm).
c.
Install the piston pin bushing (7, FIGURE 4-37).
(1)
Put the bushing (7) on the mandrel (1).
(2)
Put the sleeve (4) and then the cup (2) on the mandrel (ST-1242).
(3)
Fasten the cup (2) on the mandrel (1) with the locking pin (6).
(4)
Put the connecting rod (8) on the block (3) and hold it in a horizontal position.
(5)
Insert the mandrel (1) into the bore of the connecting rod (8).
(6)
Align the sleeve (4) with the middle of the boss on the connecting rod (8).
FIGURE 4-37. Installing Piston Pin Bushing.
4-76
|
||
|
||
