| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-5.
(c) Push the side of the bearing shell opposite the dowel ring to install the bearing shell (FIGURE
4-51) .
FIGURE 4-51. Installing the Bearing Shell.
(7) Use clean Lubriplate 105 or its equivalent to lubricate the lower thrust bearings.
CAUTION
The grooves of the thrust bearing must be toward the crankshaft.
The locating dowels must not protrude above the thrust bearing
surface.
(8) Install the lower thrust bearings in the No. 7 main bearing cap.
(9) Use clean engine oil to lubricate the capscrew threads and the flat washers.
(10) Drain the excess oil from the capscrews before installing them.
CAUTION
The main bearing caps are marked for position (1, FIGURE 4-52) on
the camshaft side and the cylinder block identification (2) on the
exhaust side. The cylinder block identification number (3) is stamped
on the pan rail on the camshaft side of the block. Install the caps in
the correct position with the position number to the camshaft side and
its part number toward the rear of the engine.
4-94
|
||
|
||
