| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-5
FIGURE 4-64.
Camshaft Bushing/Bearing Removal Sequence.
(a) To remove bushings No. 1 through No. 6, insert the tools assembly through the camshaft bore until
the driver is against the bushing.
(b) Hit the slide hammer against the shaft assembly until the bushing is driven from the bore.
(c) Using the camshaft bushing driver kit and puller, remove the No. 7 bushing. Insert the tool assembly
through the bore until the pins of the puller assembly are engaged behind the bushing.
(d) Hit the slide hammer against the T-handle until the bushing is removed from the bore.
CAUTION
Incorrect installation will result in severe damage to the engine. Refer to
the numbers stamped on the bushings to determine the correct cylinder
block cam bore location in which the bushings are to be installed. Install
the camshaft bushings in the following order: No. 7, No. 6, No. 5, No. 4,
No. 3, No. 2, and No. 1.
(2) Install the tool assembly through the camshaft bore until driver is in the cavity between the No. 6 and
No. 7 bores.
(3) Install the camshaft bushing guide in the No. 5 and No. 6 bores.
4-109
|
||
|
||
