| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-5
(4) Install the bushing marked No. 7 on the driver with the location notch to the rear of the engine and
at the 6 o'clock position.
(a) Push the bushing in the bore until the oil holes in the bushing are aligned with the drillings in the
bore.
(b) Use a 0.094 (2.39 mm) diameter rod to check the position and the location at the oil hole in the
bushing and the cylinder block.
(c) The rod must pass through the oil holes in the bushing and into the oil supply drillings in the cylinder
block.
CAUTION
The locating notch in the No. 2 through No. 6 bushings must face
the rear of the engine and be located at the 9 o'clock position when
looking at it from the front of the engine.
NOTE
Use bushing driver (1) to install bushings No. 1, No. 2, No. 4, and
No. 6. Use bushing driver (2) to install bushings No. 3 and No. 5
Install the No. 6 through the No. 2 bushings in the same manner as
No. 7.
(5) Install the tool assembly through the camshaft bore until the driver is in the cavity between the bores
where the bushing is to be installed.
FIGURE 4-65.
Bushing Driver Identification.
4-110
|
||
|
||
