| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-6
UNIT MAINTENANCE INSTRUCTIONS
Page
Section I.
Repair Parts, Special Tools; Test, Measurement, and
Diagnostic Equipment (TMDE); and Support Equipment ............................ .............................. 2-1
Section II.
Service Upon Receipt ................................ ............................................................. ................. 2-1
Section III.
Unit Preventive Maintenance Checks and Services (PMCS) ............................ ....................... 2-2
Section IV.
Unit Maintenance Troubleshooting ................................ .......................... ................................ 2-14
Section V.
Unit Maintenance Procedures ................................ ........................................................... ....... 2-17
Section VI.
Preparation for Storage or Shipment ................................. ................................ ....................... 2-32
Section I. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT,
AND DIAGNOSTIC EQUIPMENT (TMDE); AND SUPPORT EQUIPMENT
2-1. Common Tools and Equipment . For authorized common tools and equipment, refer to the Modified Table
of Organization and Equipment (MTOE) applicable to your organization.
2-2. Special Tools, TMDE, and Support Equipment . Special tools; test, measurement, and diagnostic equipment;
and support equipment requirements are listed and illustrated in the Repair Parts and Special Tools List (RPSTL),
TM 55 -1905-223-24P. These items are also listed in the Maintenance Allocation Chart (MAC), Appendix B of this
manual.
2-3. Repair Parts. Repair parts are listed and illustrated in the Repair Parts and Special Tools List (RPSTL),
TM 55-1905-223-24P.
Section II. SERVICE UPON RECEIPT
2-4. Checking Unpacked Equipment.
a. Inspect the equipment for damage incurred during shipment. If the equipment has been damaged, report
the damage in accordance with the instructions of DA Pam 738-750.
b. Check the equipment against the packing slip to see if the shipment is complete. Report all discrepancies
in accordance with the instructions of DA Pam 738-750.
c. Check to see whether the equipment has been modified.
d. Remove and replace protective caps, plugs, inserts, wrappings, and tape when inspection/inventory is
completed. Inspect piping openings for damage. Wipe off dirt, grease, or protective films at time of
installation.
|
||
|
||
