Chapter 4. INTERMEDIATE GENERAL SUPPORT MAINTENANCE INSTRUCTIONS

Custom Search

Section VI. PREPARATION FOR STORAGE OR SHIPMENT

TM-55-1905-223-24-9 Steering Gear System for Landing Craft Utility (LCU) NSN 1905-01-154-1191 Manual

Section III. INTERMEDIATE GENERAL SUPPORT PREVENTIVE MAINTENANCE CHEKCS AND SERVICES

TM 55-1905-223-24-9

CHAPTER 4

INTERMEDIATE GENERAL SUPPORT MAINTENANCE INSTRUCTIONS

Repair Parts, Special Tools; Test, Measurement, and

Diagnostic Equipment (TMDE); and Support Equipment............................................................... 4-1

Service Upon Receipt................................................................................................................... 4-1

Intermediate General Support Preventive Maintenance Checks

and Services (PMCS) .................................................................................................................. 4-2

Intermediate General Support Troubleshooting ............................................................................ 4-2

Intermediate General Support Maintenance Procedures............................................................... 4-3

Preparation for Storage or Shipment .......................................................................................... 4-24

Section I. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AN DIAGNOSTIC EQUIPMENT (TMDE);

AND SUPPORT EQUIPMENT

4-1. Common on Tools and Equipment. For authorized common tools and equipment refer to the Modified Table of

Organization and Equipment (MTOE) applicable to your organization.

4-2. Special Tools, TMDE, and Support Equipment. Special tools; test, measurement, and diagnostic equipment; and

support equipment requirements are listed and illustrated in the Repair Parts and Special Tools List (RPSTL), TN 55-

1905-223-24P. These items are also listed in the Maintenance Allocation Chart (MAC), Appendix B of this manual.

4-3. Repair Parts. Repair parts are listed and illustrated in the Repair Parts and Special Tools List (RPSTL), TM 55-

1905-223-24P.

Section II. SERVICE UPON RECEIPT

4-4. Checking Unpacked Equipment.

a. Inspect the equipment for damage incurred, during shipment. If the equipment has been damaged, report the

damage in accordance with the instructions of DA Pam 738-750.

b. Check the equipment against the packing slip to see if the shipment is complete. Report all discrepancies in

accordance with the instructions of DA Pam 738-750.

c. Check to see whether the equipment has been modified.

d. Remove protective caps, plugs, inserts, wrappings and tape when inspection/delivery is completed. Inspect

piping openings for damage. Wipe off dirt, grease, or protective film at time of installation.

Change 1 4-1