| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-9
(2) Install piston head (13) on rod (34).
(3) Install setscrew (14).
(4) Slide rod into cylinder barrel (20).
d. Head.
(1) Install bushing (11), preformed packing (10, 9), and wiper ring (8).
(2) Install head (31).
(3) Install locking tab (7) and secure with machine screw (6).
(4) Install setscrew (30) and secure with nut (33).
e. Stop.
(1) Turn threaded stop (4) and wiper (5) clockwise on rod (34).
(2) Install nut (32) and secure with setscrew (33).
f. Install equipment.
(1) Install lubrication fitting (paragraph 2-13).
(2) Install bearing and tiller pin (paragraph 3-9).
(3) Install cylinder assembly (paragraph 3-9).
ADJUSTMENT
a. Cylinder Stop Adjustment.
(1) Loosen setscrew (33) and position threaded stop (4), at extreme top of cylinder rod.
(2) Manually move steering gear to a hard-over position.
(3) Adjust threaded stop until it contacts the front face of cylinder. Tighten setscrew.
(4) Manually move steering gear to the opposite hard-over position.
b. Operate and Test.
(1) Restore power to pumpset.
(2) Check for leaks.
(3) Return pumpset to normal operation (TM 55-1905-223-10).
(4) Remove "Out of Service - Do Not Operate" tag from circuit breaker.
4-7
|
||
|
||
