| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-242-14
0072 00
SERVICE--FILTER
1.
Position a suitable drain pan beneath the filter (10).
2.
Don chemical protective gloves and goggles.
3.
Unscrew the filter (10) from the filter head (11).
4.
Clean the filter head (11) with cleaning solvent and wiping rags. Inspect the filter head for any damage that would affect
the new filter's ability to seal.
5.
Apply a film of clean hydraulic fluid to the gasket of the new filter (10).
6.
Fill the new filter (10) with clean hydraulic fluid.
! CAUTION
Do not overtighten the hydraulic filter. Overtightening can cause filter damage and/or
leakage. Proper tightening is 3/4 turn after the gasket contacts the filter head.
7.
Screw the new filter (10) onto the filter head (11) until the gasket lightly contacts the filter head. Tighten the filter another
3/4 turn past this point. Do not overtighten the filter, damage or leakage may result.
8.
Remove the lockouts and tagouts.
9.
Start the propulsion engines, operate the steering system, and check for leaks.
10. Check the hydraulic fluid level in the reservoir (3) and replenish as required.
11. Dispose of the used hydraulic fluid, cleaning solvent, and contaminated materials in accordance with local regulations.
OU
T
IN
11
10
END OF WORK PACKAGE
0072 00-3
0072 00-3/4 blank
|
||
|
||
