| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-242-14
0081 00
INSTALLATION--ENGINE SHUTDOWN CONTROL
1.
Adjust the cable adjusting nut (10) so that the upper end of the cable (7) will slide through the console far enough to
permit installation of the upper cable nut (8) and washer (9). Install the upper cable nut hand tight on the cable, and
install the T-handle (6).
2.
Secure the upper end of the cable (7) to the console by tightening the cable adjusting nut (10).
3.
Route the new cable through the vessel, securing it in the same places as the old cable.
4.
Push the T-handle (6) all the way down, and then pull it back up approximately 1/4 inch (6 mm).
5.
Install the locknut (4) and swivel fitting (2) onto the lower end of the cable (5) and adjust it so that the swivel end stud
slips easily through the hole in the governor shutdown arm (3).
6.
Secure the swivel fitting (2) to the governor shutdown arm (3) with the nut (1).
7.
Remove the lockouts and tagouts, start the engine, and test the operation of the cable.
REMOVAL--EMERGENCY ENGINE SHUTDOWN CONTROL
1.
Remove the nut (11) that secures the swivel fitting (12) to the release arm (13).
2.
Remove the swivel fitting (12) from the release arm (13).
3.
Loosen the locknut (14) that secures the swivel fitting (12) to the lower end of the cable (15).
4.
Remove the swivel fitting (12) from the lower end of the cable (15).
5.
Follow the length of the lower end of the cable (15) and remove any clamps that secure it to the engine or vessel
structure.
6.
Remove the T-handle (6) from the upper end of the cable (7) located in the pilothouse console.
7.
Remove the upper cable nut (8) and washer (9) and pull the cable out of the console.
13
11
12
14
15
0081 00-2
|
||
|
||
