| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-242-14
0083 00
REMOVAL (continued)
NOTE
Do not further disassemble the governor control rod unless replacement of one or more
of its component parts is required.
d.
Hold the coupling tube (23) and loosen the locknuts (24) to permit removal of the connecting rods (25) and the rod
ends (20), if required.
INSTALLATION
1.
Assemble and install the governor control rod assembly by using the following procedure:
a.
If the governor control rod assembly was disassembled, assemble the rod ends (20), connecting rods (25), coupling
tube (23), and locknuts (24). Adjust the length to the measurement recorded during the Removal procedure in this
work package.
b.
Install the rod ends (20) into the governor control rod and the local control unit (19), and secure them with the
lockwashers (22) and nuts (21).
2.
Connect the throttle cable to the control head in the pilothouse by using the following procedure:
a.
Drop the end of the throttle cable (6) into the engine room through the access in the pilothouse.
b.
Install the cable connector (3) and locknut (8) to the throttle cable (6).
c.
Install the cable connector (3) onto the throttle extension (7) and secure it with the bolt (2) and nut (1).
d.
Install the cable clamp (5) and secure it with the screws (4).
e.
Secure the cable to the vessel structure in the same manner as the old cable.
3.
Connect the throttle cable and articulator to the local control unit in the engine room by using the following procedure:
a.
Install the throttle cable (17) onto the cable adapter bushing (16) and secure it with the locknut (15).
b.
Pass the cable adapter bushing (16) through the hole in the local control unit (19).
c.
Tighten the clamping screw (18), ensuring that only the bottom end of the cable adapter bushing (16) is clamped in
the local control unit (19).
d.
Install the locknut (14) and articulator (13) onto the threaded rod end of the cable adapter bushing (16).
e.
Install the locknut (12) and cable connector (11) on the articulator (13).
f.
Install the cable connector (11) onto the local control head and secure it with the washer (10) and nut (9).
g.
Adjust the throttle linkage as described in the Adjust procedure in this work package.
0083 00-3
|
||
|
||
