| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-242-14
0083 00
ADJUST
1.
Disconnect the rod end (20) from the governor control rod by removing the nut (21) and lockwasher (22).
2.
Place the pilothouse control head lever for the desired engine in the full speed ahead position.
3.
Hold the governor control rod in the full speed position by hand and try to line up the rod end (20) with its hole in the
governor control rod. The rod end should be approximately 1/8 inch (3 mm) beyond its hole in the governor control rod,
such that the governor control rod will reach the end of its stroke before the throttle control reaches the end of its stroke.
4.
If the adjustment is not correct, loosen the locknut (24) and adjust the length of the governor control rod as necessary
to achieve proper adjustment.
5.
Return the pilothouse control head rod and the governor control rod to the idle position and attach the rod end (20) to
the governor control rod with the nut (21) and lockwasher (22).
6.
Remove the lockouts and tagouts and check the operation of the system.
END OF WORK PACKAGE
0083 00-4
|
||
|
||
