| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-242-14
DIRECT SUPPORT MAINTENANCE
FOR LANDING CRAFT, MECHANIZED (LCM-8) (ALL VESSELS WITH MOD 2 APPLICATION)
CYLINDER ASSEMBLY, FM-200, REPLACE
INITIAL SETUP:
Tools and Special Tools:
Personnel Required:
Tool Kit, Mechanic's Rail and Marine (Item 1,
Three Watercraft Engineers, 88L
Table 1, WP 0230 00)
References:
Equipment Condition:
FM 55-502
Engine room fire suppression pull box locked
TM 55-1905-242-24P (WP 0075)
out and tagged out IAW FM 55-502
REMOVAL
WARNING
Use two crewmembers to lift heavy loads. Heavy loads can crush. Do not allow any
body parts to come under the load or between the load and a stationary object. Failure
to comply can result in serious injury or death.
NOTE
The control head must be in the "set" position (actuating pin is in the fully retracted or
"set" position) before attaching it to the control valve to prevent accidental discharge.
Observe that the actuating pin has moved to its fully retracted position.
1.
Disconnect the swivel nut (1) on the control head (2) from the cylinder valve actuation port.
2.
Remove the control head (2) from the cylinder (3) and install its protection cap in its place.
3.
Loosen the swivel nut on the flexible discharge hose (4) and remove the flexible discharge hose from the discharge outlet
port adapter (5) and install the safety cap in its place.
4.
Remove the bolts (6) that secure the cylinder straps (7). Remove the cylinder straps.
5.
Using two crewmembers, lift the cylinder (3) from its mount to the accommodation module deck.
0176 00-1
|
||
|
||
