| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-242-14
0190 00
REMOVAL (continued)
5.
Remove the preformed packing (8 and 9) and dispose of it in accordance with local regulations.
6.
Remove the snap ring (10) and motor assembly (3).
7.
Remove the primary sun gear (11) if it has remained on the motor shaft (24).
DISASSEMBLY
1.
Remove the capscrews (12 and 13) from the port end cover (14).
2.
Lift off the port end cover (14). The gasket (15), packing (16), bushing seal (17), spacer (18), roller bearings (19), pocket
seal (20), pocket seals (21 and 22), and thrust plate (23) will be removed with the port end cover.
3.
Remove the motor shaft (24) from the shaft end cover (25). The sun gear (26) and key (27) will be removed with the motor
shaft.
4.
Match mark the sun gear (26) and motor shaft (24) to permit proper orientation during Assembly.
5.
Press the sun gear (26) off the motor shaft (24) and remove the key (27).
6.
Remove the planet gears (28) and place them with the sun gear (26). These gears are a matched set and must be kept
together.
7.
Remove the O-ring (29) and discard it in accordance with local regulations.
8.
Remove the gear housing (30).
6
0190 00-3
|
||
|
||
