| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-242-14
0190 00
INSTALLATION
NOTE
It may be necessary to rotate the motor assembly slightly so that the spline at the end of
the motor shaft will engage with the gear in the primary planet assembly.
1.
Place the winch assembly in a vertical position. Install the motor assembly (3) and primary sun gear (11) in the primary
housing (2) by holding it square with the end of the primary housing as it enters the primary housing. The spline at the
end of the motor shaft (24) will engage with the primary sun gear in the primary planet assembly and the motor will pilot
into the planet hub bushing.
2.
Install the snap ring (10) and make sure that it is properly seated in the bottom of the snap ring groove all the way around
the primary housing (2).
3.
Rotate the motor assembly (3) in the primary housing (2) to align with the match marks made during disassembly.
4.
Lubricate a new preformed packing (9) with grease and install it in its groove on the motor assembly (3). Lubricate the
preformed packing again after installation.
5.
Install the brake springs (7) in the spring cover (1). If all of the spring holes were not used when disassembled, refer to
the match marks made during Disassembly and install the springs only in the holes used previously.
6.
Lubricate a new preformed packing (8) with grease and install it in its groove in the spring cover (1). Lubricate the
preformed packing again after installation.
7.
Install the spring cover (1) over the motor assembly (3), aligning it according to the match marks made during disassem-
bly.
8.
Install the bolts (4) and seal washers (5). Tighten the bolts evenly, turning each bolt one-half turn at a time to ensure that
the spring cover (1) remains parallel to the end of the primary housing (2) as it is tightened into place. Torque the bolts
to 50 lb-ft (68 Nm).
9.
Dispose of used hydraulic fluid, cleaning solvent, and contaminated materials in accordance with local regulations.
10. Remove the lockouts and tagouts and check the operation of the system.
END OF WORK PACKAGE
01900190 00-7
00-7/8 blank
|
||
|
||
