| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-242-14
DIRECT SUPPORT MAINTENANCE
FOR LANDING CRAFT, MECHANIZED (LCM-8) (ALL VESSELS WITH MOD 2 APPLICATION)
RAMP WINCH, REPLACE
INITIAL SETUP:
Tools and Special Tools:
Personnel Required:
Tool Kit, Mechanic's Rail and Marine (Item 1,
Three Watercraft Engineers, 88L
Table 1, WP 0230 00)
Hoisting Device, 2 Ton (Item 11, Table 1,
Materials/Parts:
Hydraulic Fluid (Item 1, Table 2, WP 0230 00)
Suitable Drain Pan
Gloves, Anti-Flash (Item 13, Table 2, WP 0230 00)
Grease (Item 21, Table 2, WP 0230 00)
Equipment Condition:
Lubricating Oil, Gear (Item 23, Table 2, WP 0230 00)
Ramp lowered and supported by land, pier, or
safety chains
References:
Observe other equipment conditions contained
FM 55-502
in the procedure
TM 55-1905-242-24P (WP 0095)
REMOVAL
WARNING
Use a suitable hoisting device to lift heavy loads. Heavy loads can crush. Do not allow
any body parts to come under the load or between the load and a stationary object.
Failure to comply can result in serious injury or death.
Always wear leather gloves when handling wire rope. Handling wire rope with bare
hands can cause serious injury or death.
1.
Position one crewmember in the pilothouse to operate the winch and one crewmember on the bow ramp to receive the
winch cable. The crewmember on the bow ramp must don protective leather gloves.
2.
Have the crewmember in the pilothouse operate the winch in the RAMP DOWN position while the crewmember on the
bow ramp fakes the winch cable onto the ramp. Pay out the winch cable until all of the winch cable has been removed
from the winch drum.
3.
Remove the wedge (1) that secures the bitter end of the winch cable to the winch drum (2) and remove the winch cable
from the winch drum.
4.
Lockout and tagout the propulsion engines in accordance with FM 55-502.
5.
Position a suitable drain pan under the work area.
6.
Label and disconnect the hoses (3, 4, 5, 6, and 7) from the winch (8). Cap the hoses and the winch fittings to prevent
system contamination.
7.
Remove the tubing (9) from the winch (8). Cap the tubing and winch fitting to prevent system contamination.
0191 00-1
|
||
|
||
